Table 19-1: Routing Table Rules - AudioCodes Mediant 1000 User Manual

User's Manual
vlanMode=1
In the ini file, set the Multiple IP parameters.
2.
In the ini file, configure the Local Media and Call-Control parameters. The following is
3.
an example of these parameters in the ini file with values according to the sample
parameters above:
LocalMediaIPAddress=10.33.174.50
LocalMediaSubnetMask=255.255.0.0
LocalMediaDefaultGW=10.33.0.1
LocalControlIPAddress=10.32.174.50
LocalControlSubnetMask=255.255.0.0
LocalControlDefaultGW=0.0.0.0
Note:
Set the required static routes. The table below displays the Routing Table Rules
4.
according to the sample parameters in the example 1 and 2 as mentioned above.
Destination
130.33.4.6 255.255.255.255
83.4.87.6 255.255.255.0
The interface networks are designated as follows:
0-OAM
1-Call Control
2-Media
According to the sample parameters shown in the table above, the Routing table in the ini
file appears like this:
The following is an example of the Routing Table parameters (according to
the sample parameters shown in the table above) in the ini file:
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255 , 255.255.255.0
RoutingTableGatewaysColumn = 10.32.0.1 , 10.31.0.1
RoutingTableInterfacesColumn = 1 , 0
RoutingTableHopsCountColumn = 20,20
Each row of these parameters in the ini file is a column in the table of Routing Table Rules.
Set the EnableMultipleIPs parameter to 1. The following is an example of this
5.
parameter in the ini file:
Version 4.6
19. Appendix - Getting Started with VLANs and IP Separation
More than one interface can not be configured on the same network.

Table 19-1: Routing Table Rules

Subnet Mask
10.32.0.1
10.31.0.1
Gateway Hops Count
20
20
319
Network
Call-Control
OAM
August 2005