Figure 8-27: Configuration File Screen - AudioCodes Mediant 1000 User Manual

User's Manual
To save the ini file to the PC, take these 3 steps:
From the main menu list on the left, click on the Advanced Configuration link. The
1.
Advanced Configuration screen appears.
From the Advanced Configuration screen, click the Configuration File link in the sub-
2.
menu bar on the top. The Configuration File screen appears.
Click the Get ini File button. You are prompted to select a location in which to save it.
3.
Note:
To load an ini file from the PC to the device, take these 4 steps:
Click on the Browse button next to the Send the ini file from your computer to the
1.
device field and navigate to the location of the predefined ini file. Refer to the figure
below.
Click the Send File button. The file loading process is activated. When the loading is
2.
complete, a verification message is displayed at the bottom of the screen: File XXXX
was successfully loaded into the device.
From the main menu list on the left, click Reset. The Reset screen appears.
3.
Select the Burn option and click the Restart button. Wait for the device to reset. After
4.
self-testing, the Ready and LAN LEDs on the device's front panel are lit green. Any
malfunction causes the Ready LED to change to red.
Users can restore default parameters by clicking the Restore All Defaults button.
Version 4.6

Figure 8-27: Configuration File Screen

The ini file that you save from the device to the PC contains only those
parameters whose values you modified following receipt of the device. It
does not contain parameters unchanged at their (original) default value.
167
8. Mediant 1000 Management
August 2005