Table 12-3: Pstn Parameters - AudioCodes Mediant 1000 User Manual

ini File Field Name
CASFileName
CASTableIndex
CASTablesNum
ClockMaster
DCHConfig
DisableTrunkAfterReset
FramingMethod
User's Manual

Table 12-3: PSTN Parameters

Description
This is a pointer to the CAS filename
index (0-7). The index is
CASFileName_X. CASFileName_0
through to CASFileName_7 are the
path and names of the CAS protocol
configuration files.
Determines which CAS protocol file to
use on a specific trunk. The index
value corresponds to the number
configured for the parameter
CASFileName_X.
Range = not greater than the
parameter defining the PSTN CAS
Table Num.
This parameter defines the number of
CAS tables that are loaded to the
device during a reset. The quantity of
CAS tables defined should match the
value configured for parameter
CASFILENAME_X.
0 = when there is no CAS table to be
loaded
Selects the trunk clock source.
0 = acCLOCK_MASTER_OFF (clock
recovered from the line)
1 = acCLOCK_MASTER_ON (the trunk
clock source is provided by the
internal/TDM bus clock source
depending on the parameter TDM Bus
Clock Source)
Defines D-channel configuration. This
setting is only applicable to ISDN PRI
protocols that support NFAS and/or D-
channel backup procedures.
0 = D-channel is Primary
1 = Backup
2 = NFAS
Used to change the transmission state
of the PSTN physical device. Enable,
Disable (Tri state) or Send Blue Alarm.
0 = Trunk Enabled
1 = Trunk Disabled
Selects the physical framing method to
be used for this trunk.
224
Digital Mediant 1000
Host/Manual Valid
Default Value Range
NULL See
Descr.
0 See
Descr.
0 0 to 8
0 0 or 1
0 0 to 2
0 0 or 1
See Descr. 0, 1, a, b,
c, A, C, F
Document # LTRT-66401