AudioCodes Mediant 1000 User Manual page 220

ini File Field Name
NSEMode
NSEPayloadType
PDPattern
PDThreshold
PrerecordedTonesFileName
QCELP13Rate
QCELP8Rate
RFC2198PayloadType
User's Manual
Table 12-2: Media Processing Parameters
Description
If congestion (if the selected payload
type is already used for other
coders/modes), then a
TP_SETUP_PARAMETER_INVALID
_ERROR is issued and the payload
type is set to the default value (103).
It is the user's responsibility to avoid
congestion with other payload types.
Enables or disables Cisco's NSE fax
/ modem automatic pass-through
mode.
0 = Disable; 1 = Enable
Users can use this parameter to
modify the NSE packet's payload
type.
Defines the patterns that can be
detected by the Pattern Detector.
Defines the number of consecutive
patterns to trigger the pattern
detection event.
Defines the name (and path) of the
file containing the Prerecorded
Tones.
Range = String of ASCII characters
This parameter is used to configure
the QCELP13 coder bit rate.
0 = Variable Rate
1 = 1 kbps
2 = 3 kbps
3 = 7 kbps
4 = 13 kbps
This parameter is used to configure
the QCELP8 coder bit rate.
0 = Variable Rate
1 = 1 kbps
2 = 2 kbps
3 = 4 kbps
4 = 8 kbps
This parameter sets the RFC 2198
(RTP Redundancy) packet's
parameter 'RTP Payload Type'.
220
Digital Mediant 1000
Host/Manual Valid
Default Value Range
0 0 or 1
105 96 to 127
- 0 to 0xFF
5 0 to 31
- See Descr.
0 0 to 4
0 0 to 4
104 96 to 127
Document # LTRT-66401