User's Manual
Note 1:
Note 2:
8.6.3
TDM Bus Settings
To configure the TDM Bus settings, take these 6 steps:
From the main menu list on the left, click on the Advanced Configuration link. The
1.
Advanced Configuration screen appears.
From the Advanced Configuration screen, click the TDM Bus Settings option in the
2.
sub-menu bar on the top. The TDM Bus Settings screen appears.
Use the appropriate tables in the Appendix, ''Individual 'ini' File Parameters'' on page
3.
207
as a reference when configuring/modifying the parameter fields in the TDM Bus
Settings screen.
After configuring/modifying the parameter fields, click the Submit button. The changes
4.
are entered into the system and the screen is refreshed.
To commit the changes to non-volatile (flash) memory, on the main menu to the left,
5.
click the Reset link. The Reset screen appears.
Select the Burn option and click the Reset button. (Refer to ''Reset Button'' on page
6.
184.)
Version 4.6
A device reset may be needed in certain circumstances for the setup to be
activated, if a reset is needed the Web interface alerts the user. In case such
a device reset is needed, click the Reset link in main menu to the left,
choose the Burn option and click the Reset button to restart the device with
the new configuration.' (Refer to 'Rese't Button' on page 184.)
If you are modifying multiple screens, and a reset is required in a certain
screen, perform the reset after you are finished modifying all of the screens
you intended and NOT after each screen.
Figure 8-26: TDM Bus Settings Screen
165
8. Mediant 1000 Management
August 2005