AudioCodes Mediant 1000 User Manual page 232

ini File Field Name
EnableLANWatchdog
EnableMultipleIPs
EnableNTPasOAM
EnableSCTPasControl
EnableTPNCPasOAM
EnableTPNCPSecurity
EnableUDPPortTranslation
ExtBootPReqEnable
User's Manual
Table 12-4: Infrastructure Parameters
Description
0 = Disable; 1 = Enable
Detects LAN failures on the board. A
LAN failure can result from a software
or hardware malfunction. If a LAN
failure is detected, the board performs
a self reset (when not in PCI mode).
0 = Disable; 1 = Enable
Enables the multiple IPs feature.
0 = Disable; 1 = Enable
Sets the location of the Network Time
Protocol (NTP). If this parameter is
set and the machine is functioning in
multiple IPs mode, the NTP is located
on the OAM network. If not, the NTP
is located on the control network.
Sets the location of the Stream
Control Transmission Protocol
(SCTP). If this parameter is set and
the machine is functioning in multiple
IPs mode, the SCTP is located on the
control network. If not, the SCTP is
located on the OAM network.
Sets the TPNCP location on the
Operation, Administration and
Management (OAM) network, when
operating in multiple IPs mode.
0 = TPNCP on Control network
1 = TPNCP on OAM network
Secures the TrunkPack Network
Control Protocol (TPNCP) by
accepting only pre-determined
servers via the parameter defining
authorized TPNCP servers.
1 = Enabled; 0 = Disabled
Specifies the type of compare
operation performed on the UDP
ports. When set, the compare
operation is performed on the UDP
ports. If this parameter is set,
EnableIpAddrTranslation must also
be set.
0 = Disable; 1 = Enable
Enables extended information to be
sent in the BootP request. The device
uses the vendor specific information
232
Digital Mediant 1000
Host/Manual Valid
Default Value Range
0 0 or 1
0 0 or 1
1 0 or 1
1 0 or 1
1 0 or 1
0 0 or 1
0 0 or 1
0 0 or 1
Document # LTRT-66401