Configuring Radius Support - AudioCodes Mediant 1000 User Manual

# users - local user configuration database
john Auth-Type := Local, User-Password == "qwerty"
Service-Type = Login-User
larry Auth-Type := Local, User-Password == "123456"
Service-Type = Login-User
Make sure you have the IP address and port number used by the RADIUS server, and
3.
the configured "shared secret".
Go to ''Configuring RADIUS Support'' on page 284.
4.

16.2.2 Configuring RADIUS Support

To configure RADIUS support on the Mediant 1000 via the
Embedded Web Server, take these 7 steps:
In the Embedded Web Server, from the Advanced Configuration screen, select the
1.
Network Settings from the sub-menu bar on the top (Refer to ''Network Settings'' on
page 147).
Locate the RADIUS settings section.
2.
Fill in the RADIUS server IP address, port number and shared secret.
3.
Set Enable RADIUS access control to Enable.
4.
Set Use RADIUS for Web/Telnet login to Enable.
5.
Set Require secure Web connection (HTTPS) to Enable (HTTPS Only).
6.
It is important that you use HTTPS (secure Web server) if connecting to the device
over an open network, since the password must be transmitted in clear text over the
network. Similarly, if using Telnet, make sure you use SSL mode
(TELNETSERVERENABLE=2).
Save the configuration and restart the device. When you connect to the Web server or
7.
Telnet interface, use the name and password configured in the RADIUS database.
The old system password is still active, and may be used if the RADIUS server is
down.
User's Manual 284
Digital Mediant 1000
Document # LTRT-66401