AudioCodes Mediant 1000 User Manual page 130

The 'trap manager host name' is configured via SNMPTrapManagerHostName. For
example:
;SNMPTrapManagerHostName = 'myMananger.corp.MyCompany.com'
Note:
8.1.5.4.3 Configuration via SNMP
There are two MIB interfaces for the trap managers. The first is via the acBoard MIB that
has become obsolete and is to be removed from the code in the next applicable release.
The second is via the standard snmpTargetMIB.
Using the acBoard MIB:
1.
The following parameters, which are defined in the snmpManagersTable:
snmpTrapManagerSending
a.
snmpManagerIsUsed
b.
snmpManagerTrapPort
c.
snmpManagerIP
d.
When snmpManagerIsUsed is set to zero (not used) the other three parameters are set to
zero. (The intent is to have them set to the default value, which means TrapPort is to be set to
162. This is to be revised in a later release.)
♦
The allowed values are 0 (disable or no) and 1 (enable or yes).
♦
This is known as SNMPManagerTableIP in the ini file and is the IP address of the
manager.
♦
The valid port range for this is 100-4000.
♦
Note 1:
Note 2:
Using the SNMPTargetMIB:
2.
To add a trap destination, take this step:
Add a row to the snmpTargetAddrTable with these values: Name=trapN,
TagList=AC_TRAP, Params=v2cparams, where N is an unused number between 0
and 4
User's Manual
The same information that is configurable in the ini file can also be
configured via the acBoardMIB.
snmpManagerIsUsed Default = Disable(0)
snmpManagerIp
snmpManagerTrapPort
snmpManagerTrapSendingEnable
The allowed values are 0 (disable) and 1 (enable).
Each of these MIB objects is independent and can be set regardless of the
state of snmpManagerIsUsed.
If the IsUsed parameter is set to 1, then the IP address for that row should
be supplied in the same SNMP PDU.
Default = 0.0.0.0
Default = 162
Default = Enable(1)
130
Digital Mediant 1000
Document # LTRT-66401