Installation; Installing The Mediant 1000; Unpacking; Package Contents - AudioCodes Mediant 1000 User Manual

User's Manual
3

Installation

The equipment must only be installed or serviced by qualified service personnel.
3.1

Installing the Mediant 1000

To install your Mediant 1000, take these 4 steps:
Unpack the Mediant 1000 (refer to Section
1. Check the package contents (refer to Section
2. Mount the Mediant 1000 (refer to Section
3. Cable the Mediant 1000 (refer to Section
After connecting the Mediant 1000 to the power source, the power LED on the front panel
of the power supply unit is lit green (after a self-testing period of about 2 minutes). Any
power supply malfunction results in the LED switching off (refer to
details on the Mediant 1000 LEDs).
When you have completed the above relevant sections you are then ready to start
configuring the gateway (Section xxx on page xxx).
3.1.1

Unpacking

To unpack the Mediant 1000, take these 6 steps:
Open the carton and remove packing materials.
Remove the Mediant 1000 from the carton.
1.
Check that there is no equipment damage.
2.
Check, retain and process any documents.
3.
Notify AudioCodes or your local supplier of any damage or discrepancies.
4.
Retain any diskettes or CDs.
5.
3.1.2

Package Contents

Ensure that in addition to the Mediant 1000, the package contains:
One or two AC power cables.
Four anti-slide bumpers for desktop installation option (supplied in a small plastic bag).
CD (software and documentation).
Version 4.6
Caution Electrical Shock
3.1.1 below).
3.1.2
3.1.3 on page 38).
3.1.4 on page 39).
37
below).
Table 2-2 on page
3. Installation
28 for
August 2005