AudioCodes Mediant 1000 User Manual page 231

User's Manual
ini File Field Name
EnableDiagnostics
EnableDNSasOAM
EnableICMPUnreachable
Report
EnableIPAddrTranslation
Version 4.6
Table 12-4: Infrastructure Parameters
Description
redundancy purposes.
0 = Disable
1 = Enable (trigger by media)
2 = Enable (trigger by GARP)
3 = Enable (trigger by either media or
GARP)
Checks the correct functionality of the
different hardware components on the
board. On completion of the check,
the board sends an EV_END_BIT
value, which contains information on
the test results of each hardware
component.
0 = No diagnostics (default).
1 = Perform diagnostics (full test of
DSPs, PCM, Switch, LAN, PHY and
Flash).
2 = Perform diagnostics (full test of
DSPs, PCM, Switch, LAN, PHY, but
partial, test of Flash, a quicker mode).
Sets the location of the DNS. If this
parameter is set and the machine is
functioning in multiple IPs mode, the
DNS is located on the OAM network.
If not, the DNS is on the control
network.
Reports receipt of unreachable ICMP
packets.
0 = Disabled; 1 = Enabled
Specifies the type of compare
operation performed on the first
packet that is received on a newly
opened channel for the Network
Address Translation (NAT) feature. If
set to 1, the board compares the first
incoming packet's source IP address,
to the remote IP address stated in the
opening of the channel. If the two IP
addresses do not match, the NAT
operation takes place. Consequently,
the remote IP address and the UDP
port of the outgoing stream are
replaced by the source IP address
and UDP port of the first incoming
packet.
231
12. Appendix - Individual ini File Parameters
Host/Manual
Default Value
Valid
Range
0 0 to 2
1 0 or 1
1 0 or 1
1 0 or 1
August 2005