Paper Size And Scanned Area - Ricoh 920F Operating Instructions Manual

1. Transmission
Where original is
set
1
Exposure glass
ADF, one-sided
original
ADF, two-sided
original

Paper Size and Scanned Area

This section explains the size of the area the machine can scan and detect.
• There may be a difference in the size of the image when it is printed at the destination.
• Even if an original is correctly placed on the exposure glass or in the ADF, a margin of 3 mm (0.1
inch) around each edge of the original may not be sent.
• If the receiver uses paper of a smaller width than the original, the image is reduced to fit that paper.
• Originals placed face down on the exposure glass are scanned at A4 (8
1
at 8 / × 14, change the paper size setting with User Parameters (switch 32, bit 1) in the Fax Features
2
menu. See "Parameter Settings".
• p.226 "Parameter Settings"
When placing an original on the exposure glass
This section explains how to place an original on the exposure glass.
• If you place an original larger than A4, 8
area is scanned.
• Maximum scan area
The following shows the maximum scan area:
38
Acceptable original size
Up to A4 (210 × 297 mm),
1
8 / × 14 (216 × 356 mm)
2
A5 to A4 (up to 1200 mm
long)
1 1 1
8 / × 5 / to 8 /
2 2 2
A5 to A4 (up to 356 mm long)
1 1 1
8 / × 5 / to 8 / × 14
2 2 2
1
Maximum
number of
sheets
1 sheet
50 sheets
2
(80 g/m ,
× 14 20 lb)
50 sheets
2
(80 g/m ,
20 lb)
/ × 14 on the exposure glass, only an A4, 8
2
Paper thickness
2
52-105 g/m (14-28 lb)
2
64-105 g/m (17-28 lb)
1
/ × 11). To scan originals
2
1
/ × 14
2