GETTING STARTED
Paper Size and Scanned Area
Exposure glass
1
Reference
position
A4
A3
Document Feeder (ADF)
A4
A3
Limitation
There may be a difference in the size of the image when it is printed at the des-
tination.
If you set an original larger than DLT/A3 on the exposure glass, only the
DLT/A3 area is scanned.
Note
Even if an original is correctly placed on the exposure glass or in the Docu-
ment Feeder (ADF), a margin of 3 mm around each edge of the original may
not be sent.
If the receiver uses paper narrower than the original, the image will be re-
duced to fit the paper width. ⇒ P.99 "Auto Reduction"
The machine detects paper sizes in the following ways.
• When you set an original in the Document Feeder (ADF), an original wider
than about 7.48" is scanned as LT/LG size wide. An original wider than
about 10.37" is scanned as DLT size. Originals narrower than 9.05" will be
sent as LT/LG size. You can scan in originals of up to 17" in length.
16
A3
Horizontal size
Maximum Scanning area
A3
(297x420mm)
11"x17"
(279x432mm)
CP01AEE0
Horizontal size
Maximum Scanning area
(297x432mm)
CP02AEE1