Sending By Ip-Fax - Ricoh 920F Operating Instructions Manual

Sending by IP-Fax

This section explains how to specify a destination using IP-Fax transmission.
When using IP-Fax transmission, specify the IP-Fax destination (IP address, host name, or alias telephone
number) in place of the fax number.
• To use IP-Fax functions, the Hard Disk Drive Option and printer/scanner functions must be installed.
• To send an IP-Fax document, in the Fax Features menu, configure the IP-Fax Settings as follows. For
details about IP-Fax Settings, see "IP-Fax Settings".
• If you are using a gatekeeper server, set [Enable H.323] to [On] and configure the gatekeeper
settings under [H.323 Settings].
• If you are using a SIP server, set [Enable SIP] to [On] and configure the SIP server settings under
[SIP Settings].
1. Press [TX Mode].
2. Select [Select Line] using [ ] or [ ], and then press the [OK] key.
3. Select [H.323] or [SIP] using [ ] or [ ], and then press the [OK] key.
4. Press the [Escape] key.
The standby screen appears.
Specifying a Destination
49
1