Hostname; Ifconfig - Ricoh 920F Operating Instructions Manual

Command list display
msh> help
Display of procedure for using commands
msh> help "command_name"

hostname

Use the "hostname" command to change the printer name.
View settings
msh> hostname
IPv4 configuration
msh> hostname "interface_name" "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning "RNP" (in either upper or lower case).
• The Ethernet interface and IEEE 802.11 interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
• If you do not specify an interface, the Ethernet interface is selected automatically.
Interface name
ether
wlan
Initializing the printer name for each interface
msh>hostname "interface_name" clear name

ifconfig

Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address,
default gateway address) for the printer.
View settings
msh> ifconfig
IPv4 configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet interface.
Remote Maintenance by telnet
Interface configured
Ethernet interface
IEEE 802.11 interface
4
169