Acceptable Original Sizes; Paper Size And Scanned Area - Ricoh C9020L Operating Instructions Manual

1. Transmission

Acceptable Original Sizes

This section describes the size and thickness limitations that apply to originals placed on the exposure glass
1
or the ADF.
Where original is
set
Exposure glass
ADF, one-sided
original
ADF, two-sided
original

Paper Size and Scanned Area

This section explains the size of the area the machine can scan and detect.
• There may be a difference in the size of the image when it is printed at the destination.
• Even if an original is correctly placed on the exposure glass or in the ADF, a margin of 3 mm (0.1
inch) around each edge of the original may not be sent.
• If the receiver uses paper of a smaller width than the original, the image is reduced to fit that paper.
When placing an original on the exposure glass
This section explains how to place an original on the exposure glass.
• If you place an original larger than A3, 11 × 17 on the exposure glass, only an A3, 11 × 17 area
is scanned.
• Maximum scan area
The following shows the maximum scan area:
297 × 432 mm, 11 × 17 inches (W × L)
28
Acceptable original size
Up to A3 (297 × 420 mm),
11 × 17 (279 × 432 mm)
A5 to A3 (up to 1200 mm
long)
1 1
5 / × 8 / to 11 × 17
2 2
A5 to A3 (up to 432 mm
long)
1 1
5 / × 8 / to 11 × 17
2 2
Maximum Paper thickness
number of
sheets
1 sheet
50 sheets 40-128 g/m
50 sheets 52-105 g/m
(64-105 g/m
)
2
(11-34 lb)
2
(17-28 lb)
2
for 11 × 17