Copying From The Bypass Tray - Ricoh 920F Operating Instructions Manual

Copying from the Bypass Tray

The bypass tray allows you to copy non-standard paper.
Use the bypass tray to copy onto OHP transparencies, thick paper, envelopes, and paper that cannot be
loaded in the paper trays.
• The Duplex function cannot be performed on paper fed from the bypass tray. If [1 Sided
is selected, cancel the setting.
• Paper that has a vertical length of 90 - 216 mm (3.55 – 8.50 inches) and a horizontal length of 139
- 600 mm (5.48 - 23.62 inches) can be copied from the bypass tray. However, when paper larger
than 356 mm (14.02 inches) in size is used, the paper may become wrinkled, may not be fed into
the machine, or may cause paper jams.
• When copying onto OHP transparencies, paper of 59.9 g/m
2
above 90g/m (about 24 lb.), you need to specify the type and size of paper under Tray Paper
Settings in User Tools. For details about Tray Paper Settings, see "System Settings", Network and
System Settings Guide.
• The maximum number of sheets you can load at the same time depends on paper type. Load only as
much paper as can be held between the paper guides on the bypass tray.
1. Pull the bypass tray.
2
(about 16 lb.) or less, or paper of
BRH023S
Copying from the Bypass Tray
2 Sided]
2
27