Ricoh 920F Operating Instructions Manual page 881

2. Connecting the Machine
• If you select the [WPA] option for Security Method, select one of the following: [WPA-PSK], [WPA],
[WPA2-PSK], or [WPA2]. If you select [WPA-PSK] or [WPA2-PSK], enter your PSK. If you select
[WPA] or [WPA2], authentication settings and certificate installation settings are required. For details
about setting methods, see "Configuring IEEE 802.1X".
• For details about how to specify wireless LAN settings from the control panel on the machine, see
"Interface Settings".
2
• p.28 "Interface Settings"
• p.373 "Configuring IEEE 802.1X"
Checking the signal
This section describes how to check the machine's radio wave status.
When using in infrastructure mode, you can check the machine's radio wave status using the control panel.
1. Press the [User Tools/Counter] key.
2. Select [System Settings] using [ ] or [ ], and then press the [OK] key.
3. Select [Interface Settings] using [ ] or [ ], and then press the [OK] key.
4. Select [Wireless LAN] using [ ] or [ ], and then press the [OK] key.
5. Select [Wireless LAN Signal] using [ ] or [ ], and then press the [OK] key.
The machine's radio wave status appears.
6. After checking radio wave status, press [Exit].
7. Press the [User Tools/Counter] key.
68