Ricoh 920F Operating Instructions Manual page 433

3. Sending Scan Files Using WSD
3. Select [Network], and then press the [OK] key.
4. Select [Machine IPv4 Address] to specify the machine's IPv4 address, and then press the
[OK] key.
To specify a static IPv4 address for this machine, select [Specify], and then press the left selection key
3
to select [IP Add.]. Enter the IP address by using the number keys, and then press the [OK] key.
To obtain an IPv4 address from a DHCP server automatically for this machine, select [Auto-Obtain
(DHCP)], and then press the [OK] key.
5. Select [IPv4 Gateway Address] to make necessary settings, and then press the [OK] key.
6. Select [Effective Protocol], select [IPv4], and then select [Active]. Then press the [OK] key.
• If an extended wireless LAN board (optional) is installed, press [LAN Type] on [Interface Settings],
then press [Ethernet] and then configure the network settings.
Enabling WSD using Web Image Monitor
To use this machine as a WSD scanner, you must first configure the following settings using Web Image
Monitor on a client computer:
• Settings for WSD (Push Type) and WSD (Pull Type)
• WSD protocol (default setting: [Active])
Click [Configuration], click [IPv4] or [IPv6] under [Network], and then enable [WSD (Scanner)].
• Settings to enable WSD (Push Type)
• [Display WSD Destination List] (default setting: [Do not Display])
Click [Configuration], click [Administrator Tools] under [Scanner], and then set [Display WSD
Destination List] to [Display].
• Settings to enable WSD (Pull Type)
• [Prohibit WSD Scan Command] (default setting: [Prohibit])
Click [Configuration], click [Administrator Tools] under [Scanner], and then set [Prohibit WSD
Scan Command] to [Do not Prohibit].
Use the following procedure to enable both WSD (Push Type) and WSD (Pull Type).
1. On the [Start] menu, click [Network].
84