Ricoh 920F Operating Instructions Manual page 995

4. Monitoring and Configuring the Printer
IPX address:00000000:000000000000
Access type:read-write
Effective Protocol:IPv4/IPv6/IPX
• If "-p" is added, you can view settings one by one.
• To display the current community, specify its registration number.
Display
msh> snmp ?
Community name configuration
msh> snmp "number" name "community_name"
4 • You can configure ten SNMP access settings numbered 1-10.
• The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for
Client if "public" is not registered in numbers 1-10. When changing the community name, use
SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
Deleting community name
msh> snmp "number" clear name
Access type configuration
msh> snmp "number" type "access_type"
no
read
write
trap
Protocol configuration
Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive",
all access settings for that protocol are disabled.
msh> snmp {ipv4|ipv6|ipx} {on|off}
• Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX.
• {on} means "active" and {off} means "inactive".
• All protocols cannot be turned off concurrently.
Configuration of protocol for each registration number
msh> snmp "number" active {ipv4|ipv6|ipx} {on|off}
182
Access type Type of access permission
not accessible
read only
read and write
user is notified of trapmessages