7500-XXX
Sensor (platen length APS 1) removal
1.
Remove the large platen glass. See
2.
Remove the eight screws securing the cover (A) to the scanner unit assembly.
3.
Remove the cover (A).
4.
Disconnect the sensor (platen length APS 1) (B).
5.
Remove the screw securing the sensor (platen length APS 1) (B).
6.
Remove the sensor (platen length APS 1) (B).
Note: Ensure that the blue connector is plugged into the sensor (platen length APS 1) (B).
4-148
MFP Service Manual
"Large platen glass removal" on page
4-142.