Sensor (Tray 3 Feed-Out) On Jam (Tray 4 Media Feed) - Lexmark X850e Service Manual

244.01 Sensor (tray 3 feed-out) on jam (tray 4 media feed)

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media size setup.
Does the media size in use match the size set for tray
4?
3 Check the tray 4 rolls.
Pull out tray 4, and check it. Are the feed roll, separation
roll, and pick roll for transport free of excess wear and
contamination?
4 Check the media position.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the media touch the sensor (tray 3 feed-out) or the
sensor (tray 4 feed-out)?
5 Check the sensor (tray 4 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 4.
5. Touch Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
6 Check the sensor (tray 4 feed-out) for proper
connection.
Is the above sensor connected properly?
7 Check the connection between the 2TM/TTM controller
card assembly and the printer engine card assembly.
Are the above cards connected properly?
Check Yes
Replace the media. Go to step 2.
Go to step 3. Replace the media,
or change the media
size setup.
Go to step 4. Clean or replace the
feed roll, separation
roll, and pick roll.
Go to
dual input (TTM)–
feed roll removal"
on page
"2000-sheet dual
input (TTM)–
separation roll
removal" on
page
"2000-sheet dual
input (TTM)–pick
roll removal" on
page
Remove the media. Go to step 5.
Go to step 7. Go to step 6.
Replace the sensor Replace the
(tray 4 feed-out). connection.
Go to "2000-sheet
dual input (TTM)–
sensor (tray 4 feed-
out) removal" on
page 4-241.
Go to step 8. Replace the
connection.
Diagnostic information
7500-XXX
No
"2000-sheet
4-259,
4-263, and
4-266.
2-77