Sensor (Tray 3 Feed-Out) Static Jam - Lexmark X850e Service Manual

Step
9 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
10 Check the connection between the 2TM/TTM controller
card assembly and the printer engine card assembly.
Are the above boards connected properly?
11 Perform a print test.
Does the error still occur?
12 Perform a print test.
Does the error still occur?

243.04 Sensor (tray 3 feed-out) static jam

Step
1 Check the media position.
Does the media touch the sensor (tray 3 feed-out)?
Open the 2TM/TTM left door assembly, and visually
check it.
2 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 3.
5. Touch Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Check
Check
Yes
Replace the sensor Replace the
(tray 3 feed-out). connection.
Go to "2000-sheet
dual input (TTM)–
sensor (tray 3 feed-
out) removal" on
page 4-247.
Go to step 11. Replace the
connection.
Replace the 2TM/ Problem solved.
TTM controller card
assembly.
Go to "2000-sheet
dual input (TTM)–
2TM/TTM controller
card assembly
removal" on
page 4-274.
Go to step 12.
Replace the printer Problem solved.
engine card
assembly.
Go to "Printer
engine card
assembly removal"
on page 4-117.
Yes
Remove the media. Go to step 2.
Go to step 4. Go to step 3.
Diagnostic information
7500-XXX
No
No
2-73