Adf Registration Motor Removal - Lexmark X850e Service Manual

ADF registration motor removal

1.
Open the ADF left cover assembly.
2.
Lift the document tray assembly.
3.
Remove the ADF rear cover. See
4.
Remove the access cap (A).
5.
Disconnect the connector from the ADF registration motor (A).
6.
Remove the tension spring (B) from the ADF registration motor (A).
7.
Remove the two screws securing the ADF registration motor (A).
8.
Remove the registration main drive belt (C).
Note: Before reinstalling the ADF registration motor (A), place the registration main drive belt (C) on the
registration main drive pulley 21/54T (D).
Note: Ensure that the registration main drive belt (C) is properly routed.
Note: To correctly set the registration main drive belt (C) tension, install the ADF registration motor (A) and the
tension spring (B) before completely tightening the two screws.
Connector
"ADF rear cover removal" on page
A
Rear
4-165.
B
C
D
Repair information
7500-XXX
4-201