7500-XXX
MPF pick roll removal
1.
Remove the MPF rear cover. See
2.
Remove the MPF feed unit assembly. See
3.
Remove the two end screws securing the upper bracket (A) to the MPF feed unit assembly.
4.
Remove the upper bracket (A).
5.
Release the two hooks securing the two feed shaft cores (B), and slide them both outward.
6.
Remove the MPF pick roll (C) from the feed shaft assembly (D) by sliding it to the right in the direction of
the arrow and lifting upward.
Note: When removing the MPF pick roll (C), do not touch the rubber surface.
D
Note: Before reinstalling the MPF pick roll assembly (C), do not touch the rubber surface.
4-64
MFP Service Manual
"MPF rear cover removal" on page
A
Hook
Pin
Hook
B
"MPF feed unit assembly removal" on page
C
B
4-58.
4-54.
Left