2000-Sheet Dual Input (Ttm)-Tray 3 Mylar Actuator Removal - Lexmark X850e Service Manual

2000-sheet dual input (TTM)–tray 3 mylar actuator removal
1.
Remove the tray 3 assembly. See
page 4-217.
2.
Remove the tray 3 front cover. See
page 4-218.
3.
Remove the tray 3 rear cable assembly. See
removal" on page
4.
Remove the tray 3 front cable assembly. See
assembly removal" on page
5.
Remove the media guide rack and pinion. See
pinion removal" on page
6.
Move both media guides fully inward.
7.
Lift the front edge of the bottom plate (A) from the tray.
8.
Remove the bottom plate (A) from the tray.
9.
Remove the two screws securing the bracket (B) to the tray.
10.
Remove the rear media guide (C).
11.
Remove the mylar actuator (D) by sliding it out of the tray in the direction of the arrow.
Note: Before re-installing, ensure the bosses on the rear media guide (C) are fitted into the slots on the mylar
actuator (D) as shown in the figure.
"2000-sheet dual input (TTM)–tray 3 assembly removal" on
"2000-sheet dual input (TTM)–tray 3 front cover removal" on
"2000-sheet dual input (TTM)–tray 3 rear cable assembly
4-219.
"2000-sheet dual input (TTM)–tray 3 front cable
4-222.
4-223.
"2000-sheet dual input (TTM)–media guide rack and
A
B
C
D
Slots
7500-XXX
4-227
Repair information