Sensor (Exit 2) Off Jam - Lexmark X850e Service Manual

Step
11 Check the media diverter solenoid for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Test.
4. Touch Diverter solenoid.
Open the printer left door assembly.
Does the above component operate normally?
12 Check the media diverter solenoid for proper
connection.
Is the above component connect properly?
13 Perform a print test.
Does the error still occur?
14 Perform a print test.
Does the error still occur?

203.01 Sensor (exit 2) off jam

Step
1 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
2 Check the roll.
Open the exit 2 left door assembly.
Is the exit 2 media transport roll assembly free of excess
wear and contamination?
3 Check the drive power transmission.
Do the exit 2 media transport roll assembly and the
other gears rotate smoothly?
4 Check the roll.
Open exit 2 left door assembly.
Is the exit 2 media exit roll assembly free of excess wear
and contamination?
Check
Check
Yes
Go to step 13. Go to step 12.
Replace the media Replace the
diverter solenoid. connection.
Go to "Exit 2 media
diverter solenoid
removal" on
page 4-327.
Replace the exit Problem solved.
interface card
assembly.
Go to "Exit
interface card
assembly removal"
on page 4-116.
Go to step 14.
Replace the printer Problem solved.
engine card
assembly.
Go to "Printer
engine card
assembly removal"
on page 4-117.
Yes
Remove the media. Go to step 2.
Go to step 3. Clean or replace the
exit 2 unit assembly.
Go to
assembly removal"
on page
Go to step 4. Replace damaged
parts.
Go to
assembly removal"
on page
Go to step 5. Clean or replace the
exit 2 unit assembly.
Go to
assembly removal"
on page
Diagnostic information
7500-XXX
No
No
"Exit 2 unit
4-315.
"Exit 2 unit
4-315.
"Exit 2 unit
4-315.
2-47