7500-XXX
2000-sheet dual input (TTM)–feed unit drive gear 27 tooth removal
1.
Remove the media feed unit assembly. See
removal (tray 3)" on page 4-243
removal (tray 4)" on page
2.
Remove the harness from the bracket (A).
3.
Remove the three screws securing the bracket (A) to the media feed unit assembly.
4.
Remove the bracket (A).
Note: The gears may become detached from the bracket (A).
5.
Remove the hook securing the feed unit drive gear - 27 tooth (B) to the shaft (C).
6.
Remove the feed unit drive gear - 27 tooth (B).
Clamp
Note: Before re-installing, ensure all gears and washers are securely attached to the bracket (A).
4-268
MFP Service Manual
or
"2000-sheet dual input (TTM)–media feed unit assembly
4-239.
Harness
A
Rear
Hook
"2000-sheet dual input (TTM)–media feed unit assembly
Washer
C
B