Sensor (Registration) On Jam (Tray 2 Feed) - Lexmark X850e Service Manual

7500-XXX
Step
11 Perform a print test.
Does the error continue?

242.02 Sensor (registration) on jam (tray 2 feed)

Step
1 Check the media condition.
Is the media, in the tray, crumpled or damaged?
2 Check the media size setup.
Does the media size, in use, match the size set for tray 2?
3 Check the roll for tray 2.
Remove tray 2 and check it.
Are the feed roll, separation roll, and pick roll free of excess
wear and contamination?
4 Check the media position.
Open the printer left door assembly and visually check it.
Does the media touch the sensor (registration)?
5 Check the media position.
Open the printer left lower door assembly and visually
check it.
Does the media touch the sensor (tray 2 feed-out)?
6 Check the sensor (registration) for proper operation.
Open the printer left door assembly and check it.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Registration.
Open the printer left door assembly and check it.
Does the display, on the operator panel, change every time
the sensor actuator is operated?
2-64
MFP Service Manual
Check
Check
Yes
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-117.
Yes
Replace the media Go to step 2.
with new; ensure it
is dry.
Go to step 3. Replace the media
or change the
media size setup.
Go to step 4. Clean or replace
the feed roll,
separation roll,
and pick roll.
Go to
removal" on
page
"Separation roll
removal" on
page
"Pick roll
removal" on
page
Remove the Go to step 5.
media.
Remove the Go to step 6.
media.
Go to step 8. Go to step 7.
No
No
"Feed roll
4-45,
4-49, and
4-51.