7500-XXX
MPF/transport drive motor assembly removal
1.
Remove the rear motor cover. See
2.
Remove the rear lower cover. See
3.
Open the printer left door assembly.
4.
Remove the e-clip with needle nose pliers.
Note: This e-clip is located inside the machine behind the printer left door.
5.
Release the hook and disconnect the connector from the MPF/transport drive motor assembly (A).
6.
Remove the three screws securing the MPF/transport drive motor assembly (A) to the machine.
7.
Remove the MPF/transport drive motor assembly (A).
E-clip
Front view
4-82
MFP Service Manual
"Rear motor cover removal" on page
"Rear lower cover removal" on page
4-11.
4-12.
A
Connector
Rear