7500-XXX
Registration clutch assembly removal
1.
Remove the MPF rear cover. See
2.
Remove the MPF feed unit assembly. See
3.
Remove the printer left door assembly. See
4.
Remove the registration roll assembly. See
5.
Remove the e-ring with a prying tool securing the registration clutch assembly (A) to the registration roll
assembly (B).
6.
Remove the registration clutch assembly (A) along with the harness.
E-ring
Note:
•
Before reinstalling, the harness for the clutch must be placed through the hole on the registration roll
assembly (B).
•
Before reinstalling, the notch on the registration clutch assembly (A) must be placed over the boss of
the registration roll assembly (B).
4-80
MFP Service Manual
"MPF rear cover removal" on page
A
Notch
Boss
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
"Registration roll assembly removal" on page
B
4-58.
4-54.
4-75.
4-79.