7500-XXX
Finisher AC output removal
1.
Remove the RIP card cover. See
2.
Remove the rear motor cover. See
3.
Remove the rear lower cover. See
4.
Remove the printer engine card assembly. See
page
4-117.
5.
Remove the three screws securing the bracket (A).
6.
Disconnect the three connectors to the finisher AC output (B).
7.
Release the two hooks securing the finisher AC output (B) to the bracket (A).
8.
Remove the finisher AC output (B).
Warning: Before reinstalling, ensure all connectors are plugged into their proper location to prevent
damage.
4-126
MFP Service Manual
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Rear lower cover removal" on page
"Printer engine card assembly removal" on
A
Rear
4-13.
4-11.
4-12.
Hook
B
Hook