7500-XXX
RIP card assembly removal
Warning: In the event of replacement of any one of the following components:
•
Operator panel assembly (universal)
•
Operator panel controller card assembly
•
RIP card assembly
•
Interconnect card assembly
Only replace one component at a time. Replace the required component, and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one, or the printer will be
rendered inoperable.
Warning: Never install and remove components listed above as a method of troubleshooting components.
Once a component has been installed in a machine, it cannot be used in another machine. It must be returned to
the manufacturer.
1.
Remove the rear RIP card cover. See
2.
Remove the RIP card chassis bracket. See
3.
Disconnect the eight connections from the RIP card assembly (A).
4.
Remove the five screws securing the RIP card assembly (A) to the side of the RIP card chassis bracket
(B).
5.
Remove the six screws securing the RIP card assembly (A) to the face of the RIP card chassis bracket (B).
6.
Remove the RIP card assembly (A).
B
4-128
MFP Service Manual
"Rear RIP card cover removal" on page
"RIP card chassis bracket removal" on page
Connectors
4-13.
A
4-127.