Sensor (Tray 2 Feed-Out) Removal - Lexmark X850e Service Manual

Sensor (tray 2 feed-out) removal

1.
Remove the MPF rear cover. See
2.
Remove the MPF feed unit assembly. See
3.
Remove the printer left door assembly. See
4.
Open the printer left lower door assembly. See
page 4-70.
5.
Remove the two screws securing the tray 2 feed-out sensor guide (A).
6.
Remove the tray 2 feed-out sensor guide (A) while pulling on its center most point.
7.
Disconnect the connector from the sensor (tray 2 feed-out) (B).
8.
Release the hook securing the sensor (tray 2 feed-out) (B).
9.
Remove the sensor (tray 2 feed-out) (B).
"MPF rear cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
"Printer left lower door assembly removal" on
A
B
Hook
Connector
7500-XXX
4-58.
4-54.
4-75.
Left
A
Repair information
4-83