Too Short Size Jam - Lexmark X850e Service Manual

Step
8 Check the sensor (ADF width APS 3) for operation.
Perform the sensor (ADF width APS 3) test.
Open the ADF left cover assembly.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 3.
Operate the actuator of the sensor (ADF width APS 3).
Does the display on the operator panel change every time
the sensing area of the above sensor is blocked?
9 Check the sensor (ADF width APS 3) for connection.
Is the above sensor connected properly?
10 Perform a POR.
Does the error remain when the power is turned off/on?
11 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

295.03 Too short size jam

Step
1 Check the document size.
Is the correct size document being inserted into the ADF?
Check
Check
Yes
Go to step 10. Go to step 9.
Replace the Replace the
sensor (ADF connection.
width APS 3).
Go to "Sensor
(ADF width
APS 3)" on
page 4-186.
Replace the Problem solved.
ADF controller
card assembly.
"ADF
Go to
controller card
assembly
removal" on
page 4-167.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-128.
Yes
Go to step 2. Insert the proper
size document into
the ADF.
Diagnostic information
7500-XXX
No
No
2-125