Finisher Tests; Staple Test - Lexmark X850e Service Manual

Hide thumbs Also See for X850e:

Table of Contents

Sensor Test (output bin)

This test is used to verify that a specific output bin's sensors are working correctly.

To run the Output Bin Sensor Test

Touch OUTPUT BIN TESTS from the Diagnostics Menu.

Touch Sensor Test.

The panel displays each installed bin, one bin per line. When you select an output bin, the panel displays the

selected output bin in the header row, and then displays the name of each of the bin's sensors. You must select

a specific sensor from this list in order to view and toggle the sensor's state. After selecting a specific sensor,

[Sensor Name] Testing... the LCD displays the sensor's name in the header row and, below the header

row, the sensor's name and current state. The table below indicates which sensors are available in each output

Standard Bin

Output Bin 1

Output Bin 2

When you selects a specific sensor, the LCD displays the sensor's current state (Open or Closed). You can

manipulate the printer in such a way as to actuate the selected sensor. The LCD displays Closed when the

sensor is closed or Open when the sensor is open. If the wrong message is displayed, then the sensor must be

malfunctioning.

FINISHER TESTS

This test is used to verify the functioning of the finisher's staple mechanism.

To run the Staple Test

Touch FINISHER TESTS from the Diagnostics Menu.

Touch Staple Test.

The printer feeds eight pieces of media from the default input source to the output bin that supports stapling.

After all eight pieces of media are deposited, the device staples the packet. While this test runs, Staple Test

Running... appears on the LCD.

Std bin full

to exit the test.

to cancel the test.

Fin upper bin

Diagnostic aids

Table of Contents