Size Mismatch Jam (No Mix-Size) - Lexmark X850e Service Manual

Step
7 Check the sensor (ADF width APS 3) for connection.
Is the above sensor connected properly?
8 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
9 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

295.01 Size mismatch jam (no mix-size)

Step
1 Check the document size.
Is the correct size document being inserted into the ADF?
2 Check the document tray media guide position.
Are the document tray media guides set correctly?
3 Check the connection of each ADF controller card assembly
connector.
Is each connector of ADF controller card assembly connected
properly?
4 Perform a POR.
Does the error remain when the power is turned off/on?
5 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
Check
Check
Yes
Replace the Replace the
sensor (ADF connection.
width APS 3).
Go to "Sensor
(ADF width APS
3)" on
page 4-186.
Replace the ADF Go to step 9.
controller card
assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-167.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-128.
Yes
Go to step 2. Insert the proper
size document into
the ADF.
Go to step 3. Adjust the
document tray
media guides to
the proper
position.
Go to step 4. Connect each
connector of ADF
controller card
assembly properly.
Replace the Problem solved.
ADF controller
card assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-167.
Replace the Problem solved.
RIP card
assembly.
Go to "RIP card
assembly
removal" on
page 4-128.
Diagnostic information
7500-XXX
No
No
2-123