Invalid Combine Size Jam - Lexmark X850e Service Manual

7500-XXX

295.02 Invalid combine size jam

Step
1 Check the document size.
Is the correct size document being inserted into the ADF?
2 Check the document tray media guide position.
Are the document tray media guides set correctly?
3 Check the connection of each ADF controller card assembly
connector.
Is each connector of ADF controller card assembly
connected properly?
4 Check the sensor (ADF width APS 1) for operation.
Perform the sensor (ADF width APS 1) test.
Open the ADF left cover assembly.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 1.
Operate the actuator of the sensor (ADF width APS 1).
Does the display on the operator panel change every time
the sensing area of the above sensor is blocked?
5 Check the sensor (ADF width APS 1) for connection.
Is the above sensor connected properly?
6 Check the sensor (ADF width APS 2) for operation.
Perform the sensor (ADF width APS 2) test.
Open the ADF left cover assembly.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch ADF width APS 2.
Operate the actuator of the sensor (ADF width APS 2).
Does the display on the operator panel change every time
the sensing area of the above sensor is blocked?
7 Check the sensor (ADF width APS 2) for connection.
Is the above sensor connected properly?
2-124
MFP Service Manual
Check Yes
Go to step 2. Insert the proper
size document into
the ADF.
Go to step 3. Adjust the
document tray
media guides to
the proper position.
Go to step 4. Connect each
connector of ADF
controller card
assembly properly.
Go to step 6. Go to step 5.
Replace the Replace the
sensor (ADF connection.
width APS 1).
Go to "Sensor
(ADF width
APS 1)" on
page 4-184.
Go to step 8. Go to step 7.
Replace the Replace the
sensor (ADF connection.
width APS 2).
"Sensor
Go to
(ADF width
APS 2)" on
page 4-185.
No