Exit - Lexmark X850e Service Manual

7500-XXX
Fuser exit sensor
The fuser exit sensor detects the arrival of media at the detection point in the exit area of the fuser, and also
detects the ejection of media from this point.
Center thermistor
Pressure roll thermistor
Rear thermistor
Pressure roll
Sub heater lamp 2
Heat roll
Sub heater lamp 1
Front
Main heater lamp
Thermostat

Exit

Exit 1 ejects printed media from the printer to the standard bin 1. With the exit 2 installed, it is also possible to
eject media to the standard bin 2 by changing the orientation of the diverter gate on the exit 1.
Dual drive motor assembly
Drives the exit 1 media exit roll assembly that feeds media to each bin.
Exit 1 media exit roll assembly
The exit 1 media exit roll assembly feeds printed media from the fuser to the standard bins.
Sensor (standard bin full exit 1)
The sensor (standard bin 1 full) detects whether the exit 1 face down tray is full by moving the actuator up and
down.
1-19
General information