Error Code Messages - Lexmark X850e Service Manual

Error code messages

Error code or
message
200.00
Paper jam
Check area A
200.01
Paper jam
Check area A
201.00
Paper jam
Check area A
202.00
Paper jam
Check area A
202.01
Paper jam
Check area A
202.02
Paper jam
Check area A
203.00
Paper jam
Check area A
203.01
Paper jam
Check areas
A, E
203.02
Paper jam
Check areas
A, E
203.03
Paper jam
Check areas
A, E
Error contents
Sensor (registration) off
jam (too long)
Sensor (registration) static
jam
Sensor (fuser exit) on jam
Sensor (fuser exit) off jam
Sensor (fuser exit) off (too
short) jam
Sensor (fuser exit) static jam
Sensor (exit 2) on jam
Sensor (exit 2) off jam
Sensor (exit 2) is on in the
standard bin or simplex
finisher
Sensor (exit 2) static jam
Description/Action
The sensor (registration) is not turned off within the
specified time after the registration clutch is turned
on.
Go to "200.00 Sensor (registration) off jam (too
long)" on page 2-40.
Media remains on the sensor (registration).
Go to"200.01 Sensor (registration) static on jam"
on page 2-41.
The sensor (fuser exit) is not turned on within the
specified time after the registration clutch is turned
on.
Go to "201.00 Sensor (fuser exit) on jam" on
page 2-42.
The sensor (fuser exit) is not turned off within the
specified time after the sensor (fuser exit) is turned
on.
Go to "202.00 Sensor (fuser exit) off jam" on
page 2-43.
The sensor (fuser exit) is turned off earlier than the
specified time after the sensor (fuser exit) is turned
on.
Go to "202.01 Sensor (fuser exit) off (too short)
jam" on page 2-44.
Media remains on the sensor (fuser exit).
Go to "202.02 Sensor (fuser exit) static jam" on
page 2-45.
The sensor (exit 2) is not turned on within the
specified time after the sensor (fuser exit) is turned
on.
Refer to "203.00 Sensor (exit 2) on jam" on
page 2-45.
The sensor (exit 2) is not turned off within the
specified time after the sensor (exit 2) is turned on.
Go to "203.01 Sensor (exit 2) off jam" on
page 2-47.
The sensor (exit 2) was turned on when the media is
delivered to the exit 1 standard bin or simplex
finisher.
Go to "203.02 Sensor (exit 2) on jam in standard
bin or finisher" on page 2-49.
Media remains on the sensor (exit2).
Go to "203.03 Sensor (exit 2) static jam" on
page 2-50.
7500-XXX
2-13
Diagnostic information