Finisher Tests - Lexmark C91x Service Manual

5055-xxx

Finisher tests

Staple Test
This test verifies the operation of the staple mechanism in the
finisher.
The media is fed from the default paper source. After selecting a
destination bin, the printer feeds eight pieces of media and
accumulates them in the finisher accumulator. The printer prints an
alignment pattern during this test. After the last sheet is
accumulated, the eight sheets are stapled and fed to bin 2.
The staple test cannot be canceled or terminated once the test has
begun. As a result, no buttons are active during the execution of this
test.
Hole Punch Test
The media is fed from the default paper source. After selecting a
destination bin, the printer feeds eight pieces of media, hole
punches them, and feeds them to bin 1. The printer prints an
alignment pattern during this test. Go to
printer" on page
The staple test cannot be canceled or terminated once the test has
begun. As a result, no buttons are active during the execution of this
test.
Finisher Sensor Test
This test determines whether or not the finisher sensors and
switches are working correctly. To run the test, select the Sensor/Sw
Test operation from the Finisher Tests top level menu. The following
sensors and switches are listed in the bottom level menu:
Input Path
Paper Register
Tray 1 Exit
Tractor Home Pos.
Paper Full A
Paper Detect
Staple Home Pos.
3-20
Service Manual
3-80.
"Aligning the finisher and