Staple And Hole Punch Finisher Sensor Tests; Hole Punch Booklet Finisher Sensor Tests; Staple Finisher Sensor Tests; Motor Tests - Lexmark MS911 Service Manual

Staple and Hole Punch Finisher Sensor Tests

These tests verify that the staple and hole punch finisher sensors are working properly.
1
Remove the tray inserts from tray 1 and tray 2.
2
Enter the Diagnostics Menu, and then navigate to:
SENSOR TESTS > Staple and Hole Punch Finisher Sensor Test
3
Select a sensor.
4
Manually toggle the sensor.
Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Hole Punch Booklet Finisher Sensor Tests

These tests verify that the hole punch booklet finisher sensors are working properly.
1
Remove the tray inserts from tray 1 and tray 2.
2
Enter the Diagnostics Menu, and then navigate to:
SENSOR TESTS > Hole Punch Booklet Finisher Sensor Tests
3
Select a sensor.
4
Manually toggle the sensor.
Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Staple Finisher Sensor Tests

These tests verify that the staple finisher sensors are working properly.
1
Remove the tray inserts from tray 1 and tray 2.
2
Enter the Diagnostics Menu, and then navigate to:
SENSOR TESTS > Staple Finisher Sensor Tests
3
Select a sensor.
4
Manually toggle the sensor.
Note: The sensor status on the screen toggles between Open and Close when the sensor is working properly.

Motor Tests

PRINTER MOTOR TESTS

These tests verify that the printer motors are working properly.
1
Enter the Diagnostics Menu, and then navigate to:
Motor Tests > PRINTER MOTOR TESTS
2
Select a motor.
3
Check if the motor runs.
Service menus
195
4021, 7421