Finisher Tests; Staple Test; Hole Punch Test; Feed Test (Finisher) - Lexmark MX81 Series Service Manual

FINISHER TESTS

Staple Test

This test verifies the operation of the staple mechanism in the finisher. The printer feeds eight pieces of media to the
finisher and accumulates all eight pieces in the finisher. After the last sheets are accumulated, the pack is stapled.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Staple Test
2
Select the output bin, and press
Staple Test Running... appears while the test is running.

Hole Punch Test

This test verifies that media can be fed to the finisher output bin and then hole punched. The printer feeds eight pieces
of blank media to the finisher and then the pages are hole‑punched with a 2‑hole, 3‑hole, or 4‑hole pattern, depending
on the selected punch test.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Hole Punch Test
2
Select one of the following:
•
2 Punch Test
•
3 Punch Test
• 4 Punch Test
Hole Punch Test Running... appears while the test is running.

Feed Test (finisher)

This test verifies that media can be fed from the default source to a finisher output bin. Any size paper that is supported
can be used. The printer feeds one blank sheet of media from the default paper source to the finisher output bins.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Feed Test
2
Select the output bin, and press
Feed Tests Running... appears while the test is running.
.
.
Service menus
242
7463