Finisher Tests; Feed Test (Finisher); Hole Punch Test; Staple Test - Lexmark X95 series Service Manual

Hide thumbs Also See for X95 series:

Table of Contents

Page counts for most errors

Additional debug information in some cases

Printer information

Panel display

when error occurred

Earliest error code

The printed event log can be faxed to your next level of support for verification or diagnosis.

To print the event log, navigate to EVENT LOG > Print Log.

FINISHER TESTS

This test feeds one sheet of media from the device's default input source to a finisher output bin. The device can

perform this test using any paper size that is supported by the finisher.

This test is used to verify that media can be fed to a finisher output bin and then hole-punched. No information is

printed on the feed test pages since the printhead LED isn't engaged during this test. Eight sheets of paper are

fed, and then the pages are hole-punched with a 2-hole, a 3-hole or a 4-hole pattern depending on the selected

punch test. Although the source searching algorithm may result in paper being fed from another source, media

initially is requested from the default input source and then is transported to the finisher output bin.

This test is used to verify the functioning of the finisher's staple mechanism.

To perform the Staple Test:

From the Diagnostics Menu, navigate to FINISHER TESTS.

Touch Staple Test.

Lexmark x54x (s/n: 98P104V)

Serial number

Diagnostic aids