Zone Index & Zone Type Definitions - ADEMCO VISTA-120 Installation And Setup Manual

Zone Index & Zone Type Definitions
This section provides the following information:
Zone Index
Zone Response
Type Definitions
–68–
SECTION 19
• Zone number designations
• Zone Type Definitions
The VISTA-120 has 128 physical zones, as well as supervisory zones for relays,
ECP devices (devices which communicate through the keypad terminals), and
system troubles. These zones are designated as follows:
ZONE No. ZONE FUNCTION
001 - 128 Protection zones
601 – 696 Relay zones (to supervise relay,
use the Zone Programming menu
to enter response type 5 or 19 for
that relay's zone number)
800 - 830 ECP
(includes keypads, wireless receivers,
VIP Module, relay modules, etc.)
900 - 990 & 997 System Supervisory Zones
995, 996, 999 Keypad Panics
Response types for zones are enabled in #93 Menu mode Zone Programming.
Supervisory zones should be given a response type of either 19 (24-Hr. Trouble)
or 05 (Trouble-by-Day, Alarm-by-Night).
Each zone must be assigned a zone response type, which defines the way in which
the system responds to faults in that zone. In addition, there are three keypad
activated zones (PANIC keys) for each partition, a polling loop supervision zone,
and two RF supervisory zones, one for each RF Receiver installed. The following
table lists the zone numbers and the types of sensors that can be used with each
in this system:
Zone Sensors
1 2-wire smoke detectors (if used)
7 keyswitch (if used)
8 latching type glass break detectors (if used)
1-9 traditional wired zones
1-63 5700 series wireless devices
1-128 5800 series wireless devices
10-128 polling loop devices
995 */1 (A key) panic
996 #/3 (C key) panic
999 */# (B key) panic
Zone types are defined on the next page.
Device Supervisory
ACTUAL ZONE
As indicated
6 + 2-digit relay number
(e.g. relay number 03, if
supervised, is zone 603
Zones 8 + 2-digit Device Address,
e.g., Device Address 01, if
supervised, is zone 801. The
4285 VIP module is zone 804
(since its Device Address
must be set to 4).
988: 2nd Wireless Receiver
- not receiving signals
990: 1st Wireless Receiver -
not receiving signals
997: Polling Loop overload
995: 1+ panic (A key)
996: 3 + # panic (C key)
999: + # panic (B key)