Programming Time Windows; Daily Open/Close Worksheet - ADEMCO VISTA-120 Installation And Setup Manual

Programming Time Windows

Daily Open/Close Worksheet

Enter Scheduling Mode by entering the installer code + # + 80. The keypad
will display the Time Window programming prompt.
Time Window ?
1 Yes 0 = No 0
Time Window # ?
01-20, 00 = Quit 01
01 TIME WINDOW
00:00AM 00:00AM
When all time windows have been programmed, enter 00 at the TIME
WINDOW # prompt to quit Time Window menus.
Since the time windows are shared among all partitions, it is important to make
sure that changing a time window does not adversely affect desired actions in
other partitions.
Write in the open & close time window numbers for each partition.
Part Monday Tuesday
Op Cl Op Cl
1
2
3
4
5
6
7
8
Enter 1 at this main menu prompt to programme time
windows.
Enter the 2-digit time window number to be
programmed. Press * to accept the entry.
Enter 00 then * at the "TIME WINDOW #" prompt to
quit Time Window programming and display the Quit
? prompt.
Enter 0 at the Quit ? prompt to
return to the main menu choices
and continue programming.
Enter 1 to quit Scheduling Menu
Mode.
If a time window number was entered, the cursor will
be positioned on the tens of hours digit of the start of
window entry. Enter the desired start of window hour
and press *. The cursor moves to the minutes. Enter
the desired minutes and press *. Toggle the AM/PM
indication by pressing any key 0-9 while the cursor is
under the letter A/P position. Repeat for the end of
window time entry .
When the entry is completed, the "TIME WINDOW #"
prompt is displayed again. Enter the next time
window number to be programmed and repeat the
procedure.
Wednesday Thursday Friday
Op Cl Op Cl Op
Quit ?
1 = YES 0 = NO 0
Saturday Sunday
Cl Op Cl Op Cl
– 117 –
Holiday
Op Cl