Wiring The Vista Gateway Module - ADEMCO VISTA-120 Installation And Setup Manual

Control of Lighting and Appliances
Lighting and appliances can be controlled when an access or exit event occurs. Lights or
appliances can be automatically turned on or off when a valid entry or egress request is
presented at an access point. The Vista-120 relays or the ACS relays or triggers would be
used with keypads and/or RF transmitters whose response type is Access Point (27) to
control these devices.
Programming the Control of Lighting and Appliances
1. Enter the RELAY PROGRAMMING section in the #93 Menu Mode.
2. Programme all the information for the relay
3. Select the relay type, ECP (1) for the 4204 and X10 (2).
See the RELAY PROGRAMMING section for a detailed explanation.
Access Control Dialler Events
All PassPoint ACS events can be sent to the Vista-120's dialler via the VGM. These events
will also be logged into the control's event log. This is enabled in the PassPoint ACS. See the
PassPoint ACS documentation for a detailed explanation.

Wiring the Vista Gateway Module

The Vista Gateway Module is connected between the ECP bus, (Vista-120 keypad terminals)
and the network bus of the PassPoint Access Control System. See Figure 30 for the proper
wiring connections:
Programming the Vista Gateway Module
Set the VGM's ecp address by running the ACSTERM, which configures the PassPoint ACS.
See the PassPoint ACS documentation for a detailed explanation.
1. Enter "M" (menu mode), and then an 8 digit user code.
2. Select (1<ENTER>),
3. Configure the access system
4. Enter programme mode (1<ENTER>).
5. Select configure modules (3<ENTER>)
6. Go to the module number that the VGM is located at on the Echelon Bus of the PassPoint
ACS. This screen will have arbitrary dialler information displayed. Ignore this screen.
7. Enter (<CTRL>Z). This screen contains the VGM ecp address entry.
8. Enter the desired ecp address. This address must match the address programmed in the
DEVICE PROGRAMMING section of the #93 Menu Mode of the Vista-120.
PROM C
TRANSFORMER
Figure 30 Wiring the Vista Gateway Module
}
4-PIN
KEYPAD
PLUG
13
BLACK
}
12
GREEN TO
CONTROL'S
11
RED
KEYPAD
TERMINALS
14
YELLOW
ECHELON NETWORK
(PASSPOINT ACS)
– 63 –