Global Arming; Access Control - ADEMCO VISTA-120 Installation And Setup Manual

Global Arming

Access Control

Bypassing Zones Enter code + 6 (BYPASS) + zone number. To automatically
bypass all faulted zones, use "Quick Bypass" method: Enter
code + BYPASS + # .
Chime Mode Enter code + 9 (CHIME) . To turn chime mode off, enter
code + CHIME again.
Quick Arming: Note that if QUICK ARM is enabled (field *29), the #
can be pressed instead of entering the security code, for any
arming procedure (Away, Stay, Instant, Maximum, etc.).
User #02 must be programmed into the system in order for the Quick Arm feature to work.
SUMMARY OF ARMING MODES
Mode
Exit
Delay
AWAY Yes
STAY Yes
INSTANT Yes
MAXIMUM Yes
If enabled for the user, the keypad will display the following:
ARM ALL ? If NO, the keypad prompts for arming each partition
0 = NO , 1 = YES
individually. If YES, the system attempts to arm all
partitions allowed by this user. If there are any faults (open
doors, windows, etc.) the keypad will display them. See
notes below. These faults must be corrected or the zone
bypassed before arming will occur. When faults are
corrected, repeat the arming procedure.
1. When using the Global Arm feature, if there are faults in
any of the selected partitions, the system will enter a
summary mode in which the faulted zones of all of the
selected partitions will be displayed. These faults must be
corrected or bypassed (code + BYPASS + [#] will attempt to
bypass the faults in all of the selected partitions). This
summary mode will end in approx. 120 seconds if no keys
are pressed.
2. If, when disarming the system using a Global Disarm, any
of the selected partitions has a condition which would
cause the keypad to beep (such as alarm memory or a
trouble condition), the system will cause the keypad to
beep and will enter a summary mode in which the alarm
memory or trouble conditions of all of the selected
partitions will be displayed. This mode will continue until
either approx. 120 seconds elapses or a second disarm
occurs which clears the beeping.
Global arming cannot be performed from a wireless keypad.
If programmed in data field 1*76, one relay may be used for access control in each
partition. To activate this relay: User code + 0 .The relay will pulse for 2 seconds.
In addition to this command, there are three other commands (#73, #74, #75) that
can control access points shared with the PassPoint Access Control System. Refer to
the Access Control section for details on these functions.
-
Features For Each Arming Mode
Entry Perimeter
Delay Armed
Yes Yes
Yes Yes
No Yes
No Yes
key
Interior
Armed
Yes
No
No
Yes
- 151 -