ADEMCO VISTA-120 Installation And Setup Manual page 104

Zone Alarm Reports
ALARM, ID DIGIT?
1 = YES
ENTER ZONE NO.
000 = QUIT
001 REPORT CODE
1st 00 2nd 00
ENTER ZONE NO.
000 = QUIT
QUIT REPORT MENU
1 = YES 0 = NO
Restore/Supervisory Codes
RESTR, SUPV. CODE
1 = YES
ENTER ZN FOR GRP
000 = QUIT
ALARM RESTORE
GRP 001-016
TROUBLE
GRP 001-016
TROUBLE RESTORE
GRP 001-016
BYPASS
GRP 001-016
BYPASS RESTORE
GRP 001-016
ENTER ZN FOR GRP
000 = QUIT
QUIT REPORT MENU
1 = YES 0 = NO
– 96 –
Press 1 (Y) to enter alarm report codes for zones.
0 = NO 0 Press 0 (N) to skip to the next main menu option.
Enter the zone number for which you are entering
001
the report code. Press
Enter the first digit of the alarm report code
00 (double-digit entry) and press
digit of the alarm report code. Press
Enter the zone number for which you are entering
001
the report code. When all zone alarm codes have
been programmed, enter 000 to Quit. Press
If you have completely finished entering report
0
codes,
Programming mode.
system report codes, enter 0(N) and press
Press 1 (Y) to enter restore and supervisory codes for zones.
0 = NO 0
Enter one zone for each group of 16 zones (001-016, 017-032,
001 etc.)
Enter the first digit of the alarm restore report code for this
00
group of zones (double-digit entry). The second digit will be
the ID (second) digit of the alarm report code for each zone (if
programmed). Press
Enter the first digit of the trouble report code for this group
00
of zones (double-digit entry). The second digit will be the ID
(second) digit of the alarm report code for each zone (if
programmed). Press
Enter the first digit of the trouble restore code (single-digit
00
entry) and press
digit of the alarm report code for each zone (if programmed).
Press
Enter the first digit of the bypass report code (double-digit
00
entry) and press
digit of the alarm report code for each zone (if programmed).
Press
Enter the first digit of the bypass restore report code (double-
00 digit entry) and press
(second) digit of the alarm report code for each zone (if
programmed). Press
Enter one zone for each group of 16 zones. When finished
017 entering restore and supervisory codes for all zone groups,
enter 000 and press
If you have completely finished entering report codes, press 1
0 (Y) to quit Report Code Programming mode. If you wish to
enter other system report codes, enter 0 (N) and press
continue.
to continue.
press 1 (Y) to quit
If you wish to enter other
to continue.
to continue.
. The second digit will be the ID (second)
to continue.
. The second digit will be the ID (second)
to continue.
The second digit will be the ID
.
to continue.
to continue.
. Enter the 2nd
.
.
Report Code
.
to