ADEMCO VISTA-120 Installation And Setup Manual page 105

System Group 1 Codes
SYSTEM GROUP #1?
1 = YES 0 = NO 0
CLOSE
1st 00 2nd 00
QUIT REPORT MENU
1 = YES 0 = NO 0
System Group 2 Codes
SYSTEM GROUP #2 ?
1 = YES 0 = NO 0
STAY
1st 00 2nd 00
QUIT REPORT MENU
1 = YES 0 = NO 0
System Group 3 Codes
SYSTEM GROUP #3 ?
1 = YES 0 = NO 0
EARLY OPEN
1st 00 2nd 00
QUIT REPORT MENU
1 = YES 0 = NO 0
To enter System Group #1 codes, press 1 (Y).
Enter the first digit of the Closing (Arm-Away) report. Press
. Enter the second digit of the report. If the user number
is desired as the second digit, enter 01 (not necessary for
Contact ID or High Speed formats). Press
Enter the rest of the codes in the same manner. Other codes in
System Group #1 are:
• Opening (Disarm)
• System Low Battery
• Low Battery Restore
• AC Mains Loss
• AC Mains Restore
Once you have entered these report codes, the system will prompt:
If you have completely finished entering report codes, press 1 (Y)
to quit Report Code Programming mode. If you wish to enter
other system report codes, enter 0 (N) and press
To enter System Group #2 codes, press 1 (Y).
Enter the first digit of the Arm-Stay report. Press
second digit of the report. If the user number is desired as the
second digit, enter 01 (not necessary for Contact ID or High Speed
formats). Press to continue.
Enter the rest of the codes in the same manner. Other codes in
System Group #2 are:
• Time Set, Log Reset
• Log 50%, 90% Full
• Event Log Overflow
Once you have entered these report codes, the system will prompt:
If you have completely finished entering report codes, press 1 (Y)
to quit Report Code Programming mode. If you wish to enter
other system report codes, enter 0 (N) and press
To enter System Group #3 codes, press 1 (Y).
Enter the first digit of the Early Opening report code. Press
Enter the second digit of the report Code. If the user number is
desired as the second digit, enter 01 (not necessary for Contact ID
or High Speed formats). Press
Enter the rest of the codes in the same manner. Other codes in
System Group #2 are:
• Early Close
• Late Open
• Late Close
• Failed to Open
Once you have entered these report codes, the system will prompt:
If you have completely finished entering report codes, press 1(Y)
to quit Report Code Programming mode.
other system report codes, enter 0(N) and press
to continue.
• Periodic Test
• Power
• Cancel
• Programme Tamper
• Callback Request
.
. Enter the
• Autobypass by Zone
• Autobypass by User
• Recent Close
continue.
to continue.
• Failed to Close
• Auto-Arm Failed
• Schedule Change
If you wish to enter
to continue.
.
– 97 –