Wireless System Installation Advisories - ADEMCO VISTA-120 Installation And Setup Manual

Wireless System
Installation
Advisories
Installation and
Setup of the
4281/5881/5882EU
Wireless
Receivers
MOUNTING
HOLES
1. Place the receiver in a high, centrally located area for best reception. Do not
place receiver on or near metal objects. This will decrease the range and/or
block transmissions. Do not mount receivers or transmitters in an attic,
where extreme temperatures could prevent proper operation.
2. For maximum range, install the wireless receiver at least 3 meters from the
Control panel or any keypads to avoid interference from the microprocessors
in these units.
3. If dual receivers are used:
A. Both must be at least 3m from each other, as well as from the Control
panel and remote keypads.
B. Each receiver must be set to a different Device Address (01-07). The
receiver set to the lower address is considered the 1st wireless receiver
for supervisory purposes.
C. The house IDs must be the same (applies only to 5700 series or if using a
5827/5827BD wireless keypad).
D. Using two Receivers does not increase the number of transmitters the
system can support (63 zones using 4281H; 128 zones using the
5881H/5882EU) plus a wireless keypad).
1. Mount the receiver(s). Receivers must be mounted externally to the control
and can detect signals from transmitters within a nominal range of 60m.
Take this into consideration when determining mounting location.
2. Connect the receiver's wire harness to the control's keypad terminals (6, 7, 8,
and 9). Plug the connector at the other end of the harness into the receiver.
3. Refer to the installation instructions provided with the receiver for further
installation procedures regarding antenna mounting, etc.
4. Set the receiver's DIP switches for an address (01-07) which is not being used
by another device (i.e., keypads, relay modules, etc.).
ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
CIRCUIT
BOARD
INTERFERENCE
INDICATOR
LED
Figure 14a: 5881 Wireless Receiver (cover removed)
5839EU/5882EU NOTES
• 5882EU cover must be removed before enrolling 5839EU keypad into receiver.
• Each 5839EU can be enrolled in only one 5882EU (do not assign a given
5839EU to more than one transceiver).
PLUG
&
SOCKET
DIP SWITCH
:
YELLOW
}
RED
TO CONTROL'S REMOTE
BLACK
KEYPAD CONNECTION
GREEN
POINTS. EACH RECEIVER
MUST BE ON INDIVIDUAL
WIRING
HOME RUN.
OPENING
ON OFF
KNOCKOUT
AREA FOR
SURFACE
WIRING
– 31 –